The Seat Are Done!
Replies to This Discussion
-
Permalink Reply by Michael Vogler on
-
Tony,
The leather came from SMS Auto Fabrics. It's a little pricey, but the leather and hole patters and shapes are perfect. (I believe that SMS has some of the the original Cadillac leather dies. It sure looks like it). After placing the order, which you have to pay in advance, I received my leather in about 2 months.
I don't know who the upholsterer is as he was subcontracted through my body shop. But, I will find out and let you know.
As an aside, I'm a bit worried about scratching up the leather (my wife has two miniature schnauzers that must go everywhere with her and their nails will do terrible damage to the glove leather). Do you have any advice on clear plastic seat covers? (I can't believe I even have to ask that question..but you pick your battles. ;-)
Cadillac had a clear cover as an option in 1964, but of course NOS/OEM covers would almost certainly not be serviceable, if you can even find one.
Mike
-
-
Good point about who I would be saving the interior for...the next owner? As I've instructed my wife, there will be no next owner as I intend to be buried in my Deville! (I know that it's selfish to deprive someone of enjoying the car down the road, but if I'm going to Heaven (or Hell, as the case may be), I'm goin' there in style!)
Mike
-
Permalink Reply by Jason Edge on
-
Very Nice!
-
Permalink Reply by Tony Prichard on
-
How much did that run you altogether if you don't mind my asking? Thanks!
Members
Forum
Logans Intake Project, 1964 Fleetwood, Progress Report #1
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 16 hours ago. 4 Replies 0 Likes
I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue
Rear main seal
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill yesterday. 4 Replies 0 Likes
Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue
1963 Cadillac differential 3.25
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Thursday. 2 Replies 0 Likes
I have a 1963 Cadillac differential with 80K on it. Found a limited slip a while back, and I do not think I will ever used the original diff. In is in carlsbad California 92009. Let me know if you…Continue
headlight / dimmer switch confusion (63 Sedan Deville)
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 3 Replies 0 Likes
The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
