Hi I am new to this Discussion  I currently purchasing a 64 Deville convertible and It has bias ply tires that are 15 year old  they have L-78-15 tires and would like to put on radials . Question  what is a good cross to radial tire and is l-78-15 the original tire size. Thanks  Mark

Facebook Facebook

Views: 753

Reply to This

Replies to This Discussion

GM made radials standard on almost all of its car lines in 1975, replete with a special tread pattern developed by GM to be used with Goodyear and Firestone tire designs. 

The Eldo and Fleetwood were optionally available with radials starting in the '73 model year (maybe '72 in some instances) but radials didn't become standard on all Cadillac models until 1975. 

Lincoln beat Cad by a country mile, as the '70 Mark III was the first American car with radial tires. The Continental got 'em too.  Michelin X, as I recall. 

And yes, radials do everything better than bias-ply tires.   Only for big car shows would I ever again put bias ply tires on my classic cars. 

Thanks Tony!  I'm full of otherwise-useless automotive trivia.  Nice to have this Cadillac forum to share some of it with.  

Van

Diamondback Tires will custom make your sidewall however you want it.

I special ordered a set of their tires for my '71 Imperial, and they exactly matched the Imperial-unique double-whitewall design. My car has its original spare tire, and I sent them pix of it as a guide.

I am amazed at how accurate they were able to make the new tires' sidewalls look.

No need anymore to settle for a wrong style.  

Anyone know the name of the correct wheel weights? I know they are getting harder to find. 

Thanks

RSS

Photos

  • Add Photos
  • View All

Forum

Logans Intake Project, 1964 Fleetwood, Progress Report #1

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 3 hours ago. 4 Replies

I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill 15 hours ago. 4 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

1963 Cadillac differential 3.25

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Thursday. 2 Replies

I have a 1963 Cadillac differential with 80K on it. Found a limited slip a while back, and I do not think I will ever used the original diff.  In is in carlsbad California 92009.  Let me know if you…Continue

headlight / dimmer switch confusion (63 Sedan Deville)

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 3 Replies

The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service