Transmission Mounts
Thanks to Jason making a 900 mile trip thru Illinois, I am moving forward with pulling the trans on my Fleetwood and replacing it with the one Jason is bringing for me!
That being said, I’ve already been in contact with Fatsco to order some of the other seals I’ll need. Fatsco did NOT have the trans mounts however.
Since the mounts will be accessible while the trans is out of the car, might as well replace on those. Where would be a reputable source for these mounts?
Further, how do I ensure everything is lined up properly? Are there shims needed as well? Is there a guide that I should follow?
As always, thanks for the help!
Replies to This Discussion
-
Permalink Reply by Russ Austin on
-
You can get the rear mount at CaddyDaddy.com It is a better mount than the stock one. Same shape and size, but engineered better so it wont collapse like the originals.
The trans has guide pins and will self align to the engine. The rear will almost take care of itself, just have the mount bolts centered in the bolt holes.
-
Permalink Reply by Logan Robb on
-
Would engine mounts be more accessible during this operation as well?
Members
Forum
The $120,000 1963 Eldorado on Bring a Trailer
Started by Jason Edge in General Discussion. Last reply by Kurt 3 hours ago. 6 Replies 0 Likes
I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue
Fuel Supply System - Check Points Beyond the Fuel Pump
Started by Jason Edge in General Discussion 5 hours ago. 0 Replies 0 Likes
Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas. It has gotten to the point I have copied and…Continue
Front grill
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 13 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Houston we have a problem!
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Monday. 3 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
