I bought a 1963 Series 62 Convertible in July.

It makes a hissing sound when in neutral, and sometimes when in drive (when the shift is more to the left that the right. I assume this related to a NSS vacuum issue - does that seem correct?

In addition, the parking brake does not latch. From what I've read here, it seems the NSS issue causes the parking brake to fail to release, not fail to latch - do I have this right? The parking brake itself works as I have slowly driven the car and carefully pressed it down, and it does slow the car.

Any thoughts on first steps to troubleshoot? Any good sources for a NSS if that is what I need?

Facebook Facebook

Views: 417

Reply to This

Replies to This Discussion

The parking brake will not latch when the car is running and put into gear. It should latch in Park & Neutral or when the car is off in any gear. One of the functions of the NSS is sending vacuum to the parking brake release when the car is in gear. Check you vacuum lines going to the NSS & to the parking brake. If the hoses are good/attached, it could be vacuum leak elsewhere (NSS, parking brake diaphram, etc)

Thanks! The brake won't latch when the car is in park - perhaps it just needs some lubrication on the catch

There is a vacuum valve on the NSS, and that routes vacuum to a vacuum canister on the parking brake.  When in park, vacuum does not flow to the parking brake.  Once in Drive or Reverse, vacuum goes to the parking brake.   Check the lines and canister for a vacuum leak.  But it is common for the vacuum valve on the NSS to fail.

If the vacuum valve on the NSS is leaking I have a good one that holds vacuum tight for $20 + s/h. 

RSS

Photos

  • Add Photos
  • View All

Forum

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson 6 hours ago. 5 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

Logans Intake Project, 1964 Fleetwood, Progress Report #2

Started by Logan Robb in 1963/64 Cadillac Specific Discussion 8 hours ago. 0 Replies

Hello all!Just a short update this evening!I wrestled with the exhaust manifold studs and ultimately chickened out on replacing all 4 of the studs. I only replaced the stud that I spun the threads…Continue

Scout Shows up in the Garage with "Man Bun" to Work on Cadillac!

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 12 hours ago. 1 Reply

Cheryl brought my 4 1/2 month old boy Scout out to the garage in a man-bun to help work on the Cadillac. Sometimes you just have to roll with it! (I am scared to see who she will "dress up" Bandit…Continue

Logans Intake Project, 1964 Fleetwood, Progress Report #1

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 20 hours ago. 5 Replies

I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service