I have spent a few hours trying to get pump to pump fluid. The lines are all clear, The pump Is working as it should when the washer button is pushed. I have a spare wiper motor assembly which I have switched parts around with. The diaphragm is in good condition, The only idea I have at this point is that the seal around the valves is leaking. I tried to coat the seal with Vaseline but no difference.

Any ideas where to go next?

Does any body out there have any idea if the seal is available anywhere?

Facebook Facebook

Views: 127

Attachments:

Reply to This

Replies to This Discussion

Once I get the rebuild kit installed, I'll let you know how I made out.

Wayne

Wayne,

     If it is the W/W pump piston itself, I also have a rebuilder who is great.  Jason's contact is a great recommendation!

Dennis DiBari

Yesterday I installed the windshield washer pump kit, I primed it and it worked! I did have to clear nozzles and replace the lines to them but all is working now. 

Thanks all who contributed.

Wayne Morris

Great news Wayne!  

Dennis DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

Front door handle lights not working

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Wednesday. 3 Replies

My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue

Vintage Promo Picture #4 - 1963 Fleetwood 60 Special in Nevada Silver

Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Wednesday. 0 Replies

Here is the 4th picture in my collection of "Promo Pictures" - another 1963 Fleetwood 60 Special.  This 60 Special appears to be Nevada Silver, Paint Code 14.  …Continue

Tags: Picture, Promo, Vintage, 1963

lighted headlight switch

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Saturday. 2 Replies

I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service