hi all
i need an intake manifold it anyone can advise if they know of one. also I have sourced one here in Australia but it appears to be off a 1960 engine. I have been told 3 stories - one that it will bolt in - one that it will need an extra gasket and one that it wont fit. anyone have any experience fitting older intake manifolds to 64 engines>?
Added by john chalk on September 11, 2012 at 7:32pm — 13 Comments
hi all
a few techy questions for answers please
I have a new cancel cam to fit - how easy to remove steering wheel to fit the cam?
Power boot release (in glove box) = vacuum line missing. where could it be?
Trunk light out in dash cluster - how to replace
thanks
Added by john chalk on September 4, 2012 at 4:48am — 4 Comments
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dave Fehrle 5 hours ago. 4 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion 7 hours ago. 0 Replies 0 Likes
I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock. Did not know.Just had engine…Continue
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes
I'm looking for some info and hopefully some pictures on the commercial chassis dual battery setup. Is the second battery tray (driver side) , the same as the passenger side or is it mirrored? I'm…Continue
Started by Jason Edge in Chapter Discussion yesterday. 0 Replies 0 Likes
Chapter member Alan Clark and owner of a 1964 Eldorado sent this and wanted to share with everyone in case there are others nearby that might want to attend:"I'd like to invite the 63/64 chapter…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by