Latest Activity
vacuum lines B4
"Hi Wayne. Rick Yasenchack here. In your picture "vacuum lines B4, the copper line going into intake manifold-did this just side into mainfold without any fitting?
I'm thinking this is a source of low compression to the…"
August 17, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up at Zoom
August 17, 2025 from 8pm to 9:30pm
Our next Virtual 1963/64 Cadillac Chapter Meet-Up will begin Sunday, August 17, 2024 at 8pm Eastern (7pm Central, 6pm Mountain, 5pm Pacific). Email invites will be sent to Chapter Members a few days prior and on the day of the meet-up. If not a member of the Cadillac & LaSalle Club and our 1963/64 Chapter, check out the many benefits at www.benefits.cadillaclasalleclub.org then join at…See More
"My sedan has an aftermarket booster and master cylinder. The brake pedal is rock hard as in there is no swish in the pedal before there is braking, or another way to say it is there is no pedal drop before I have brakes being applied. "
August 17, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up at Zoom
August 17, 2025 from 8pm to 9:30pm
Our next Virtual 1963/64 Cadillac Chapter Meet-Up will begin Sunday, August 17, 2024 at 8pm Eastern (7pm Central, 6pm Mountain, 5pm Pacific). Email invites will be sent to Chapter Members a few days prior and on the day of the meet-up. If not a member of the Cadillac & LaSalle Club and our 1963/64 Chapter, check out the many benefits at www.benefits.cadillaclasalleclub.org then join at…See More
"Does anyone have a ‘64 cruise control speed selector? The plastic mount for the selector cable is broken on the one I have, so the cable cannot connect. "
"I’m puzzled by your reply 🤔. You stated aftermarket will be rock hard and same time one on your sedan and works great???"
"I will check on that Monday, the hose is new I know. Will check size and type "
"How is the vacuum hose I wrote you about?
Dennis DiBari"
"He is only pulling about 12-15 off the carb, was going to play with timing which needed tweaking and he thought it would improve some
booster looks aftermarket and was new when I purchased, and always hard pedal.
Im just about to get car…"
"If the booster is an aftermarket one, they are rock hard on the pedal. I have one in my sedan and the brakes are great. A vac pump is not necessary unless the vacuum is low. if the vac is low, then there are engine problems, not brake…"
For sale; Hydra Matic transmission
Known good Hydra Matic transmission for a 63 64 Cadi.Came out of my driving 63 coupe. I went the LS route.Resealed the pan, speedo drive, front and rear seals.Comes with a new rear mount.625.00 located in Vail AZ. U pick up or I can put it on a pallet to ship. I use engineshipping.com all the time. Please email me at russ@thecadishack.com…See More
"Hi Rick,
A lot of GM car owners make the mistake of having a 3/8" gas line hose from the check valve on the booster to the back of the carburetor. Please make sure that you have/get a Certified 11/32" Vacuum…"
"Make sure there is good vacuum going to the booster, and that the check valve is working. "
"Hi Dave,
Sent you two private emails about the joint. Hope you received them.
Dennis DiBari"
"Finally had received the new rear spherical joint and time to replace it. Bought grade 8 bolts, nits and washers. Ended up taking yoke out, put on new joint and pressed on the rubber cover. Toghtened everything up and reinstalled yoke. Took it for a…"
Brake Booster not enough compression
I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock. Did not know.Just had engine reworked and I completely redid brakes. Engine back in and running, brakes still like rock. Mechanic only getting about 12-15psi I beleive he said. He is not sure what to do other than add electric booster pump, going to test booster in morningAny suggestions before summer ends in OhioSee More
"Hi Kevin, Welcome to the 63/64 Cadillac Chapter & Website. Be sure to tell us more about your 63 convertible with the LS swap. Pictures would be fantastic! Jason. "
"This was not on any of the 4 1964 Series 75 (6723 & 6733) I pulled in and parted during the day and not in the 75 series literature, but Commercial Chassis Cars went out to coach builders who I could see installing a 2nd battery for the extra…"
Members
Forum
Brake Booster not enough compression
Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 8 Replies 0 Likes
I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock. Did not know.Just had engine…Continue
Add cruise control/Aftermarket Cruise control
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler yesterday. 16 Replies 0 Likes
Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue
For sale; Hydra Matic transmission
Started by Russ Austin in General Discussion on Friday. 0 Replies 0 Likes
Known good Hydra Matic transmission for a 63 64 Cadi.Came out of my driving 63 coupe. I went the LS route.Resealed the pan, speedo drive, front and rear seals.Comes with a new rear…Continue
Houston we have a problem!
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Thursday. 5 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
