front seat crest
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?See More
Latest Activity
"Thanks, Bill. That makes sense.
This will have to wait as I am now in the middle of tracing down a short and a radio issue in my 64 Imperial. NOTE: Because the dash top comes right off on the Caddy, it is MUCH easier to do any work behind the dash…"
"I recently had to replace my water pump on my 63 SDV which I believe is original because the hose had the three ripples along the one side. BTW, this pump was cast iron. Well, taking it off, one of the 1/4" and one of the 3/8" bolts broke…"
"Norm, I was able to get enough of the end of the lower passenger side climate control bulb to get it out but was not able to get it back in that way. So what I did to replace that socket was to use a 17mm 6 point socket and a short extension to…"
"Here are some photos of the new tires on the Eldorado:"
"Would love to see some photos of the tires you have!"
"I agree with this laundry list! While shes open, may as well replace what needs replacing!"
"I am in the process of swapping over to an Edelbrock 1406. Take a look at my profile to see my progress so far. My Page - 63/64 Cadillac Website"
"SK,
I sent you a friend request so I can send you the pics of my kick panel. We have to be friends so the website will let me send a message.
Bill"
"Michael, You would remove the intake manifold and replace the gaskets with the block off style gasket, or you could use regular gaskets and just cut a piece of tin and place over the exhaust crossover port on each side. I also removed the heat riser…"
"Thanks for the reply Chris. This sounds like a good approach to addressing the performance issue while retaining as much originality / authenticity appearance in the engine compartment as possible. Did you actually replace the intake…"
1963 RHS A/C kick panel - photos needed
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.Many thanks,-SamuSee More
"I have installed an electric chock on my 4GC Rochester carb. I also installed Olson intake gaskets with the exhaust cross over blocked. I have electric chock stats on hand for the Rochester , you can also purchase them from Mikes Carburetor . If…"
"Did you end up figuring this out?"
Photos
Members
Forum
front seat crest
Started by Frank Murch in 1963/64 Cadillac Specific Discussion 11 hours ago. 0 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
64 Replacing dash illumination lights-how much has to come out to get to all of them?
Started by Norman Silverman in General Discussion. Last reply by Norman Silverman 12 hours ago. 11 Replies 0 Likes
Hello AllI have taken off my dash top and started replacing dash bulbs with LED's for greater visibility. Some questions:1) To replace the Gauge bulb it looks like easier access is had by removing…Continue
Correct whitewalls
Started by Richard Stanley in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf 20 hours ago. 3 Replies 0 Likes
I just replaced my tires from Diamondback (I had bad results in the past from Coker). It was the second time, due to the age of the tires. About 18 years ago Diamondback made custom whitewalls…Continue
lighted headlight switch
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 21 hours ago. 4 Replies 2 Likes
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
© 2025 Created by Jason Edge.
Powered by
