Peter Greenway
  • Male
  • Camberley
  • United Kingdom
Share on Facebook
Share on Facebook MySpace
  • Blog Posts
  • Discussions (13)
  • Events
  • Photos
  • Photo Albums
  • Videos

Peter Greenway's Discussions

Pertronix Ignition Power Relay Installation.

Started this discussion. Last reply by Peter Greenway Jan 12. 11 Replies

Has anybody installed the Pertronix power relay for the Pertronix ignitor electronic ignition?I have installed one on my 63 car and as per the instructions I had to also install the isolation diode…Continue

Replacement seat cover kits.

Started this discussion. Last reply by Peter Greenway Jan 30, 2023. 3 Replies

Hello, I have a 63 4-door sedan and want to replace all the seat covers on the front bench and rear seats. Can anyone recommend the best place to buy the complete seat kits (already stitched up)…Continue

63 Lower Front Bumper Ends?

Started this discussion. Last reply by Peter Greenway Sep 26, 2022. 3 Replies

I'm looking for 2 good condition lower front bumper ends for a 1963 car. Can anyone help please?Continue

 

Peter Greenway's Page

Latest Activity

Peter Greenway replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"It seems the generator has gone faulty and only putting out 2.0v. I would guess I've damaged the internal diodes inside the rectifier."
Jan 12
Peter Greenway replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"I've managed to get a wire through the cranking harness grommet and connected it to the ACC switched terminal. When connected to the coil I still got the same results with the GEN light. So I removed the relay, wiring and diode and reinstalled…"
Jan 11
Jason Edge replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"With lower instrument panel (dash) cover below steering column removed and with a good light you should be able to fish a wire through grommet and see it coming through and pull toward the fuse box. Just to note, The dash pad comes out…"
Jan 8
Peter Greenway replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"If I use the cranking harness grommet can I get to it up under the dash without removing the pad?"
Jan 8
Jason Edge replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"The cranking harness grommet dead center behind engine is probably your best route. You should see a rubber plug over on left driver side even if not used. It is just another option for running wires, etc into the cabin.  See oval plug/grommet…"
Jan 8
Peter Greenway replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"Thanks Jason I will look at the Pertronix Ignition comparison page. I have found the ACC fuse terminal on the side of the box and although it is being used I can tap into that ok. See attached picture.  I don't have a rubber grommet under…"
Jan 8
Dave Fehrle liked Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
Jan 7
Jason Edge replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"That is an ignitor I series unit. The oldest unit and one I think you would want to skip over once you read out Pertronix Ignitor Ignition & Flamethrower I, II, and III Comparison  Help Page. You will still need to get a…"
Jan 7
Peter Greenway replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"I can understand what you are saying Russ. If I I run a new switched wire from the fuse box, what's the best way to get it through the fire wall to the coil? I'm attaching pictures of the Pertronix instructions to clarify things, I…"
Jan 7
Peter Greenway replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"Just to clarify I haven't installed the Pertronix ignitor yet. I started with the power relay first to ensure I had full 12v feed to the ignitor as per the instructions. My Pertronix model number is 1181LS. I will attached pictures of the…"
Jan 7
Russ Austin replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"Remove the isolation diode from the scene. Run a switch power wire to the coil and that will solve your problem. You can remove the resistor wire but you will need to take the dash pad off to access the ignition wire harness where it is spliced into…"
Jan 7
Jason Edge replied to Peter Greenway's discussion Pertronix Ignition Power Relay Installation.
"I had run the Ignitor II 91181 for about a decade then the Ignitor III 71181 sine around 2012 and neither requir installation of an "isolation diode". There is mention of a "diode fix" for other applications in the instructions…"
Jan 7
Peter Greenway posted a discussion

Pertronix Ignition Power Relay Installation.

Has anybody installed the Pertronix power relay for the Pertronix ignitor electronic ignition?I have installed one on my 63 car and as per the instructions I had to also install the isolation diode in the wire from number 4 terminal on the regulator to stop current back feeding to the new relay which would keep the engine running with the ignition key off. I now find that when first switching on the ignition (before cranking), the GEN light is lit but it's only very dim. Also when the engine is…See More
Jan 7
Peter Greenway updated their profile
Nov 30, 2023
Peter Greenway replied to Peter Greenway's discussion Replacement seat cover kits.
"I should state my seats are cloth and vinyl, not leather. Thanks."
Jan 30, 2023
Peter Greenway replied to Peter Greenway's discussion Replacement seat cover kits.
"Thanks Lee, but my seats are cloth and vinyl. Sorry I should have stated that. Thanks anyway."
Jan 30, 2023

Profile Information

Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
1963 Series 62 4 door sedan 4 window. Colour; Briar Rose.
Cadillac LaSalle Club Membership Number? (Must be a member to Join Chapter & Website)
34251
1963/64 Cadillac Chapter Member?
Yes

Comment Wall (1 comment)

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

At 6:53pm on November 18, 2021, Jason Edge said…

Welcome to the 63/64 Cadillac Website.

This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter. 

- Click on www.join.6364cadillac.com for more information on joining the 1963/64 Cadillac Chapter and the Cadillac LaSalle Club.

Be sure and check out all the links and pages and make yourself at home. The Help Page at www.help.6364cadillac.com will have links to many useful articles and information about our Cadillacs.

 
 
 

Photos

  • Add Photos
  • View All

Forum

64 cadillac deville convertible interior

Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 1 Reply

Hello everyone. I am trying to sort out a interior order that came to me with the wrong diamond pattern and no buttons. They are going to fix it but I would like to include some pictures of the…Continue

Dino Diaries - Power Vent Window Video Discussion

Started by Jason Edge in General Discussion Nov 27. 0 Replies

Here is a short clip after a cruise around town today, discussing optional power vent windows and an intermittent problem I have with my left power vent. Continue

2025 calendars are ordered.

Started by Russ Austin in General Discussion. Last reply by Russ Austin Nov 25. 2 Replies

The 2025 63 64 Cadillac wall calendars have just been designed and ordered. I only order 50 and I sell out each year, so get yours early to guarantee a calendar.$15.00 plus shipping. Please email me…Continue

64 Deville Fuel Tank Sending Unit

Started by Jeff Tepper in Restoration Discussion. Last reply by Russ Austin Nov 25. 1 Reply

HI all,I replaced my sending unit with a no name one off ebay and it is all over the place. It does not even attempt to have any accuracy.We may try to fix the original unit. Seems like we need to…Continue

Blog Posts

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service