I have a perfect circle cruise control. My speedometer is not working. It turns going into the "Perfect circle" but not out. When I fiddle with it, the speedo works for a short time. The cables (from tranny and to dash) seem to seat correctly. Any idea how to fix this?
Also, does anybody know where to send these out for rebuild?
Thanks
Tags:
Nope, I graduated HS in 1979 and this was my HS car. I have noticed your posts for years, I am in San Diego and the car is very good, but I think yours may be better. Mine is a driver
No, but thank you for drawing my attention to that section. The car was just a car back in the day. It was not worth much. Over the years when things wore out or broke, I just replaced them. I have changed my mind over time, the car has become much more valuable and I have started repair/replace with original or restored parts now. I have been studying the thing for a whole day and I think the issue is the spring nuts on the cable drives, either the wheel cable, or the speedo head cable are not tight, the gears drop out of position, lock up and the speedo reads dead.
What I would really like is to have it rebuild and swap the thing out. I probably can repair it, but a total rebuild would be nice. I am also getting older and I don't really want to spend the time, or get under the car of get dirty any more.
Started by Rob Spring in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata yesterday. 1 Reply 0 Likes
I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by