Here is another part I have seen many times but might not be familiar to many and will post up as our next trivia question.

So, looking at the pictures below ... WHAT IS IT?

Views: 37

Reply to This

Replies to This Discussion

OK. This trivia may need some hints:
- There are two of them
- Located in interior of the car
- Helps secure something.

I believe it’s the stud that hold the dash pad to the dash

BINGO! These are the small ball studs that screw into the two vertical legs of the dash pad (upper instrument panel cover), and push into metal clips on the dash to help hold it in place.  Of course pulled used after 60 years they are usually more of a rusty color. Here is one of a few I threw into the cadmium plating batch.

Phillip..... HAVE A CIGAR!!!!

RSS

Photos

  • Add Photos
  • View All

Forum

63 Cadillac no electrical power

Started by David Erickson in General Discussion. Last reply by Dennis P. DiBari 2 hours ago. 1 Reply

I have a 63 cadillac park avenue.  My bulbs in the door panels in the front driver and passenger sides were out.  I replaced them today and no illumination.   My battery is fully charged and I tried…Continue

DIDGAKNOWTHAT? - Notches for Holding License Plate Door Open when "Filling Up!"

Started by Jason Edge in General Discussion. Last reply by Jason Edge 12 hours ago. 3 Replies

I casually mentioned during our Zoom meeting Sunday that there are notches for using the gas cap to hold the license plate door open while filling up and a couple of members indicated they did not…Continue

Hesitation on starting after driving

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Friday. 28 Replies

I have noticed that after I drive for 5-10 miles or more and then shut off the car, it hesitates when I go to start? Anyone experience this before and if so, what was the fix?Continue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dave Fehrle on Friday. 12 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service