Mark Bartlett's Discussions (38)

Discussions Replied To (23) Replies Latest Activity

"I ran out of my 15 minutes Also see Jason's pics of motor mount placement probably s…"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Hello everyone again  I finally got both motor mounts in there was a couple of littl…"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Thanks for your input"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Thank you so much about the placement I probably would not have noticed that . I hav…"

Mark Bartlett replied Sep 14, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Yaw mounts on the trans you mean those 2 little rubber mounts on the side     I have…"

Mark Bartlett replied Sep 13, 2023 to 64 Deville motor mounts replace

9 Sep 14, 2023

"Hi Patrick I sent  my clock to you today  let me know when you get it"

Mark Bartlett replied Aug 28, 2023 to 2 clocks that work

2 Aug 28, 2023
Reply by Mark Bartlett

"I am sure this is going to happen to me Thanks again"

Mark Bartlett replied Jul 26, 2023 to Back end of Cadillac doesnt seem Right when going over speed bumps

8 Jul 26, 2023
Reply by Mark Bartlett

"Hi A little update  Thanks Kurt for finding that ball joint in rear article I didnt…"

Mark Bartlett replied Jul 26, 2023 to Back end of Cadillac doesnt seem Right when going over speed bumps

8 Jul 26, 2023
Reply by Mark Bartlett

"Do you know who has them I called Advance auto and they talked to me like I didnt kn…"

Mark Bartlett replied Jul 18, 2023 to Back end of Cadillac doesnt seem Right when going over speed bumps

8 Jul 26, 2023
Reply by Mark Bartlett

"Ok Thanks "

Mark Bartlett replied Jun 26, 2023 to Timing chain cover R&R

14 Jun 26, 2023
Reply by Mark Bartlett

RSS

Photos

  • Add Photos
  • View All

Forum

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dave Fehrle 8 hours ago. 1 Reply

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 22 hours ago. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Getting hot when going fast…

Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 6 Replies

So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue

Rainstorm out of nowhere!

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply

After dinner last night, we went for a quick cruise as the weather was cooler and the sun set was looking really good!Out of nowhere, a pop up shower appeared overhead and down-poured as we were…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service