My Eldorado has bucket seats.  The controls lack tilt.  Is this how they came? 

ithe door mounted control knob has forward/back and up/down but, no tilt.  
the up down isn’t working at the moment and forward/back is sluggish and pulls more from one side of the tracks.  

Facebook Facebook

Views: 111

Reply to This

Replies to This Discussion

They came with 4 way (up, down, forward, back) on the driver side, and 2 way (forward and back on the right side).  If you want them to tilt back you can always unbolt front and add some rubber blocks under the front.   

- For non movement check the transmission on the left driver side for dried grease. Unbolt driver seat, flip back, and remove the transmission, open the case, and remove all dried grease especially on the slide rods that the electromagnetic actuators engage to pull the gears together to make the seat cables spin. The grease dries up and prevents movement of the actuators. Click on Seat Transmission - Cleaning the 6-Way and 4-Way Seat Transmissions to go to our Help Page for a visual and more details on cleaning. 

- For slow movement, unbolt seat, flip back clean out the tracks with WD40, 0000 steel wool, compressed air and whatever you have to work with. Also check that the main ground wire is secured to the floor. It usually a thick blue wire with an round connector that goes under one of the seat rail to floor bolts. Give the bolt and extra snug and make sure it is tight.  Also makes sure seat left and right rails are in same relative position front to back. Simply measure from front or back for equal distance.  Motor could be tired and burning out but usually cleaning and greasing seat rails and checking that ground will do the trick. Also make sure the seat harness connectors at motor and transmission are making good contact. Pull apart and clean if unsure. 

Thank you for answering the question. 
I was just watching the online dealers information and trying to pause the slideshow on the Eldorado seat page.  

‘’I’ll copy down the repair details for action when time permits.  

RSS

Photos

  • Add Photos
  • View All

Forum

Logans Intake Project, 1964 Fleetwood, Progress Report #1

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 8 minutes ago. 4 Replies

I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill 12 hours ago. 4 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

1963 Cadillac differential 3.25

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Thursday. 2 Replies

I have a 1963 Cadillac differential with 80K on it. Found a limited slip a while back, and I do not think I will ever used the original diff.  In is in carlsbad California 92009.  Let me know if you…Continue

headlight / dimmer switch confusion (63 Sedan Deville)

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 3 Replies

The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service