I just received a repop KleerView bottle and label for my 64 Fleetwood this morning. Wondering where the best location for this bottle would be? Or rather, where was it most commonly installed?
I really enjoy these period correct details and I think they make really fun conversation pieces at car shows!
Logan
Side note, you can still get GM OptiKleen fluid at the Dealer. I've always thought the washer fluid was better when they would top it up at the dealer after a service of my 2008 CTS. Now I know why, they have their own stuff! Not bad for a $10 bottle of concentrate.
Tags:
Check out this album. https://6364cadillac.ning.com/photo/albums/kleer-view-bottle-and-la...
Jason does most things right, so it's probably accurate : )
That is the location t have always found them on parts cars that had them. Have probably brought in 4 or 5 of them over the years.
Thanks Kurt and Jason! That is where mine shall go.
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Sunday. 1 Reply 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Saturday. 2 Replies 1 Like
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Robert Alan Shannon May 13. 9 Replies 0 Likes
I’m starting the complete rear suspension update/upgrade-new springs and shocks,replacing spherical joint and bushings on yoke and control links! Just wondering if there are any tips to help with the…Continue
Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin May 12. 4 Replies 0 Likes
I’m struggling with my TV rod adjustment. I’ve been trying to adjust it as per shop manual, but it’s still not OK. When cold, it shifts smoothly through all four gears, when hot, it hesitates (lots…Continue
Tags: adjustment, rod, TV
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by