I am considering replacing the shocks in my 64 SDV. They're not terrible, but are a little too wishy-washy. I want to replace them with shocks that most closely approximate the original damping rate so that the original ride feel is not changed.
I am NOT after "handling" or anything that will firm up the ride -just as smooth a ride as was intended by our cars' manufacturer.
So, who likes what for this?
Thanks
Norm
Tags:
I have been running and selling the Gabriel Gas Cushioned shocks as a good new replacement for at least 20 years now! The front shock is 82109, and the rears are 82125. They give excellent "shock absorption and dampening". The will of course not do anything to fix the support, or non-support rather, of 60+ year old coil springs. The only issue with he Gabriel shocks has been that the upper stud on the rears are a bit short to get both rubber bushing on, and you have to cut one thick bushing in halve, or find thinner bushings. I simply cut them in half. The set that are on my car now, again have been there I'm guessing 20 years. If I had driven the car harder or put more miles I might swap them out, but for now they work great.
I do keep a few sets on hand and sell these for $35 each to non-members, or $25 to Chapter Members.
You can also find them at various places online, but have not searched recently. If interested in a set email me.
There are probably other good gas cushioned shock substituted but I have no experience with other brands. Jason.
These Gabriel Gas shocks are excellent! A great recommendation.
Dennis DiBari
Thanks, Dennis
Thanks, Jason. I will contact you privately
Norm
Travis J. Hensley Online
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 1 hour ago. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion 4 hours ago. 0 Replies 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Started by Bobby Brown in General Discussion. Last reply by Logan Robb 8 hours ago. 2 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by