Norman Silverman's Blog – December 2018 Archive (4)

Brighter Headlights. What to install that won't draw too much current.

My car still has its "T-3"headlamps and they shed poor, yellow-tinted light. I'd like to replace them with something that most folks on this web site use, that would shed good light and don't heat up the wiring with too many amps. 

Survey says?

Norm

Added by Norman Silverman on December 15, 2018 at 9:07pm — 11 Comments

Although the radiator was not leaking, nor was the car running hot, I tool out the radiator today to have it boiled out and rodded out. Then I changed the oil and filter (filter is very easy to reach…

Although the radiator was not leaking, nor was the car running hot, I tool out the radiator today to have it boiled out and rodded out. Then I changed the oil and filter (filter is very easy to reach with the radiator out), then the thermostat got changed. 

I'll have the radiator back from the shop on Monday, and will reinstall it then. 

Still having…

Continue

Added by Norman Silverman on December 8, 2018 at 9:29pm — 6 Comments

Trunk Light Socket Very Strange?

I went to replace the bulb in the trunk light socket and was met by something I had never seen before: the socket appears to be made in two thicknesses. First a wide one with appropriate cut outs on the side where the bulb nipples fit in, then a long slender shaft (with a cardboard tubular insert) down to the positive contact. I've never seen anything like this. Only thing I can figure is that it is designed to have a metal rod inside the cardboard shaft that…

Continue

Added by Norman Silverman on December 4, 2018 at 10:14pm — 2 Comments

Comfortron Power Module Reinstalled; BLOWER BLOCKAGE FOUND!!

I got the rebuilt Power module back from the rebuilder and reinstalled it.

It's been a while since i posted on this topic so I will remind those reading that the main problem I have been chasing is that i can't get air out of the AC or the heater ducts-even though the heat/ac vacuum solenoid is working. Today, I found out why.

I installed the newly rebuilt Module but it…

Continue

Added by Norman Silverman on December 4, 2018 at 12:51am — 2 Comments

Photos

  • Add Photos
  • View All

Forum

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe yesterday. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth on Saturday. 15 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Future of CLC Judging

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge Jun 11. 6 Replies

First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system.  The old system was very good, however, I believe what Bill and the…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service