From Jason's Garage - 1964 Cadillac Power Window Relay Testing

Quick video showing how to test a Power Window Relay from a 1964 Cadillac with case removed and things to look forward that cause them to stop working. This would be applicable for other auto electrical relays.

Views: 430

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on August 9, 2024 at 9:53am

Matti, Glad the video helped. I had actually forgotten about this video!

Comment by Matti Roth on August 9, 2024 at 2:41am

Thanks Jason again! 
Power windows in my 64 worked only in emergency position so I started to inspect the relay. Found out that it was stuck. Easy fix with your video instructions and now I have power windows in my caddy!

Comment by Jason Edge on March 31, 2017 at 12:26pm

I would bypass unless you plan on adding a lock out switch... and then you run the possibility of where to mount the switch if your 63 has power door locks, since the 63 power door lock switches were mounted at very front of arm rest switch plate, instead of up on the door panel as in 1964.

Comment by Jason Edge on March 31, 2017 at 7:42am

Ian, The 1964 Window Relay works in conjunction with the Cut-Out switch (lock out switch), found on 1964 Cadillacs but not on 1963 Cadillacs. It is located behind the carpeted lower left kick panel and mounted to the car body via 2 5/16" hex head metal screws. It is referenced in the 1964 Cadillac Shop Manual on page 16-110, Fig 16-128. I have insured a crop in of the llustration seen in Fig 16-128 below:

Comment by Jason Edge on March 17, 2017 at 5:38pm

Went back and added a 2nd part showing testing of continuity across the high current circuit after relay case was reinstalled.

Photos

  • Add Photos
  • View All

Forum

Power Booster Install

Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 3 hours ago. 5 Replies

Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue

Complete Front End Rebuild

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata on Thursday. 1 Reply

I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue

1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly

Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply

Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering.  Also, possibly looking for an oil filter housing assembly for a 1964 429 motor.  Starting to get…Continue

A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies

As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 13 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service