I have noticed that after I drive for 5-10 miles or more and then shut off the car, it hesitates when I go to start? Anyone experience this before and if so, what was the fix?
Tags:
Hi Dave,
That is the regulator radio capacitor. They are used to prevent points from burning and to reduce radio static for the AM radio. This may have an effect. I would replace it and try the new harness from regulator to the alternator. I double grounded the regulator to the frame to make sure. Did you check the 6 amp in line fuse - check it is not blown. P.S. I had to try a new regulator TWO times. They are not made as well as they used to. The second regulator did it, with all of the above that I mentioned. Hope this helps.
Dennis DiBari
The item circled is to suppress radio noise only. The capacitor for the points is on the coil. Wde did discuss the ignition switch having 4 positions, are you in the "OFF" position and not the far left "ACC" position?
Some aftermarket ignition switches do not have the ACC position.
Ok, I installed the new VR and then started the car and GEN light stayed on, no matter the RPM. So then I kept the new VR and installed the regulator harness I bot from Russ(thanks). GEN light stayed on when I started.
I did check the 6amp fuse and it was intact. I have never had GEN light stay on before all the “new” parts. Also, GEN light stayed on with and without the radio suppressor installed.
I guess the next step is to test alt by disconnecting batt cable while running and see what happens?
Or should I get a different VR?I am having the alt rebuilt to 100 amp and will still have GEN light capability, is there a specific VR I should use? Solid state?
GEN light can stay on if your Alternator is bad or not creating current. A quick way to see if they are working is to take a steel wrench and touch the rear center section. If working, it will be magnetized and draw the wrench (or any other Metal) to it.
Another quick way to see if alternator is working (assuming cranking/charging wiring is all correct) is to crank the car and disconnect the positive battery cable while still running. The car should continue to run from the output current of the alternator.
And of course you can just have your alternator tested at most auto parts stores.
Hi Dave,
While the car is running, what is the volt output on the voltmeter with everything connected? You should be putting out about 14.3 volts. My light stayed on last spring because the regulator was bad (the readings went from 9 volts to 17 volts - very erratic and dangerous). Changed the harness, two regulators, double grounded the regulator, and had alternator rechecked. Jason is right. Get the alternator checked as well. Dealt with this issue a few weeks back in the spring.
Dennis DiBari
Before any of the changes, it was 16-17. Then only 12 and change after each change. I will test alt.
Dave,
With the erratic shift in voltage, it sounds like a regulator. Seventeen volts could blow your dash lights. Be careful not to run it long. Check alternator, then do the regulator.
Dennis DiBari
With the new VR its at 12, so now I’m thinking alt is not charging enuf.
Correct. Alternator may do it.
Dennis DiBari
Pop the battery cable off while running. If it shuts off you know the alternator is not working as it should or wiring isn't correct. I would double check all the connections, especially at back of alternator.
I followed Jason’s instruction and removed batt cable while car was running and it immediately died! So pulled alt. and having it rebuilt for 100 amps. I’m going to replace batt cables and would like to get the M & H spring ring’s, but can i use them with 100 amp alt?
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 5 hours ago. 4 Replies 0 Likes
Coil Springs is one part I generally do not sale (who wants a tired used coil spring), but it is also one of those items I just can't let go up. I have painted them, stuck lights in them, put them…Continue
Started by Jason Edge in General Discussion yesterday. 0 Replies 0 Likes
North Carolina can be pleasant in the winter, with temps mild (60's/70's in the day and 40's and 50's at night); however, yesterday when I got up it was 20, and the has been in the mid 40's, Today it…Continue
Started by Jason Edge in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 1 Reply 5 Likes
To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue
Tags: ebay
Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Tuesday. 1 Reply 0 Likes
Hello everyone. I am trying to sort out a interior order that came to me with the wrong diamond pattern and no buttons. They are going to fix it but I would like to include some pictures of the…Continue
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
ContinuePosted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
© 2024 Created by Jason Edge. Powered by