Wiper Motor Relay Coil Sticking
All,
My 1963 Series 62 convertible's wipers sometimes stay on after I turn them off. This is annoying as I usually have to find a speedbump or pothole to hit to turn them off!
The issue is that the relay coil (marked in image below) is sticking. Is there any recommended lubricant or other fix to prevent this coil from sticking? It looks like it would be a hard and tedious job to replace it, if I could even find the right coil.
Any and all thoughts appreciated!
Karl Schwarz
Centreville, VA
Replies to This Discussion
-
Permalink Reply by Kurt on
-
I had that problem. My wipers would also take several seconds to start after after the switch was turned on. In my case it was a very easy fix. I just removed the wiper motor front cover, cleaned up all the old hardened, sticky grease with solvent and re-greased the mechanism. It has worked perfectly since then (10 years). I just used regular bearing grease.
-
Permalink Reply by Karl Schwarz on
-
Kurt, Thanks. I actually did what you described, and it improved things quite a bit, but the sticking relay coil still sometimes causes the problem. What kind of grease did you use to re-grease?
-
Permalink Reply by 3ft7bqmb7dryo on
-
Look here for the problems. Both areas need to move freely.
Members
Forum
Website Header - Experimenting with Rotating Member Cars
Started by Jason Edge in General Discussion. Last reply by Jason Edge yesterday. 6 Replies 2 Likes
I was thinking or rotating member 63's and 64's up in the header and used Mark Geertsma's 1963 Sedan de Ville as a test car. It gets a little grainy making the picture that small, but not too bad.…Continue
My Only Eldorado Parts Car - A 1963 Picked up in 2001
Started by Jason Edge in General Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes
I was thumbing thru parts car folders and run across the 63 Eldorado I parted out way back in 2006 and saw the dirty but good condition body tag. I like to clean them up I guess as a token and of…Continue
Anybody in Reno or Lake Tahoe area?
Started by Mack in 1963/64 Cadillac Specific Discussion on Sunday. 0 Replies 0 Likes
We have a group of Cadillac guys in Reno/Tahoe area and we will be cruising and participating in the local car shows this season!let me know if you’re in the area and wanting to join in.happy…Continue
Adapt, Improvise and Move an Cadillac Engine!
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Friday. 3 Replies 0 Likes
Just wanted to pop in and say hello and give a quick update on a couple of things and share a garage thing I thought you might get a kick out of. First, my arm is out of the brace as of last Monday…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
