Comment
Hi Dave,
It sounds like you checked everything. As Jason said, there is a normal vacuum sound when you remove the air cleaner. I have a 4-barrel Rochester on my 64, so it is a bit different than your Carter. If you checked all the lines that Jason mentioned, then you should be OK. The booster, vacuum advance, PCV valve are all big vacuum items.
Dennis DiBari, Cottekill, NY
With the air cleaner off you will get an air sucking sound. I listened to your video not sure I hear anything too out of the ordinary. With cleaner on do you still hear loud or pronounced air sound?
If all of your vacuum hoses are good and tight and you have checked the devices they operate (e.g. vacuum advance, brake booster, throttle check valve (if equipped), AC idle speed-up control, if equipped, etc. If you have issues inside the cabin I don't think you would hear from engine compartment. For that with car running stick your head under dash, with AC/Heat on moving controls then try to set unset park brake via gear shift (obviously not with head still under dash).
You should be able to isolate a specific leak, but again you do get a sucking sound when you take that air cleaner off. I will try to give mine a listen with filter off and compare but it is raining cats and dogs here right now and cannot get car outside.
Is the car running badly? Sounds normal to me.
Had some time today to check vacuum hoses out of the manifold as well as the one into the carb from the dist check valve. All 3 were good with no hissing. Even took them off and pushed air thru with no holes or splits. I took a video of the carb while the car was running to get the sound from the carb(see attached).
I believe my heat riser is stuck in closed position, thus causing left exhaust to flow thru the manifold and that is what is making the sound. Any other ideas?
Thank you for all the helpful ideas, I will start the search and report back!
what size is the small vacuum line coming off the manifold?
Not sure about the paper over the carb but the hissing is not normal and is, almost always, a vacuum leak. In order to help find the leak, you can go to your parts store and buy about 3' of rubber vacuum hose (any size) and use it as a makeshift stethoscope. Once back in your garage, put one end in your ear and move the other end across your running engine and the hiss will get very loud when you move the open end of your hose over the leak. Viola! You've found the leak.
I hope this helps you find your issue.
Hi Dave,
As Chris said, put your ear close to each of the vacuum hoses around the carburetor and intake manifold. With the heat, they become brittle. Look specifically at the 11/32 vacuum hose to the check valve off the power brake booster (it must be 11/32 vacuum hose, not 3/8 heater hose!!!). Also, look at the vacuum hose cluster coming out of the firewall - they go to the heat control valve and the vacuum pot near the heater core. My hoses cracked at the firewall, and I had to repair them to get my heater to work again. Good luck and let me know!
Dennis DiBari, Cottekill, NY
Travis J. Hensley Online
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal yesterday. 2 Replies 0 Likes
So I have been having problems with my brake lights. At first I thought it was both sides and turns out it is only the drivers side. Also, I thought the blinker worked and it didn’t and turned out…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 11 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Nile Bolen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 4 Replies 0 Likes
I checked the Help page and did a search on the site but didn't see any subjects on steering play/slack. Since I had someone complete a front end rebuild (Kanter kit, all the control arm bushings,…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler on Monday. 12 Replies 0 Likes
Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website