Speedo Cable lubricant
Eventually I’ll replace the speedo cable if needed but I believe the dash will need to come out to do that. However, shortly, I will be replacing the transmission on my 64 Fleetwood and I was wondering when we plug the Speedo cable into the new trans, is there a lubricant I can get into there? It makes noise especially when cold. Figure it might help a little.
Thanks!
Logan
Also, I’ll upload a few photos of the “Craigslist Rebuild” I did on the trans. No full rebuild, but the case and pan sure looks better! Hoping this used trans from Jason does the trick until I can find a shop that’ll touch a 64 TH400
- Attachments:
-
-
IMG_6991.jpeg, 4.5 MB -
IMG_6990.jpeg, 5 MB
-
IMG_7007.jpeg, 3.8 MB
-
Replies to This Discussion
-
Permalink Reply by Logan Robb on
-
-
-
-
Permalink Reply by CHRIS CARLSON on
-
Logan ,Remove the dash pad and unscrew the speedo cable from the speedometer pull the cable from the housing, spray some brake cleaner on a rag and run it down the cable to remove the old grease until its clean you may want to spray some brake cleaner down the cable housing until it runs out the other end then blow the housing dry with a blow gun. Then lube the cable with white lithium grease or vaseline and reinstall it into the housing that should end your noisy cable.
-
-
This sounds like a good plan however, I don’t plan to remove my dash at this time. That’s why I was wondering if there was a lube I could get into from the trans side.
I know what you suggested is the right way to do it, but I’m not taking dash off right now. So got to do what I can
Photos
Members
Forum
Clock Repair
Started by Michael Vogler in General Discussion. Last reply by Dennis P. DiBari 13 hours ago. 6 Replies 0 Likes
63/63 Owners,The clock in my '64 just went out. It appears that the mechanical component is working properly, so I think the coil has failed. I contacted Jerry at Clockworks and he advised that he…Continue
No dash lights, headlights only come on with dimmer
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton 15 hours ago. 6 Replies 0 Likes
I’m in the midst of refreshing some things in my dash. I got my passenger ash tray working for the first time ever apparently, evident by the factory defect tag. “While I’m in here I might as well…Continue
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler 16 hours ago. 14 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Down and Out for a Couple of Weeks --> but On the Mend
Started by Jason Edge in General Discussion. Last reply by Michael Vogler 16 hours ago. 3 Replies 0 Likes
I have been more than a bit quiet the past couple of weeks due to a really bad fall January 31 where I tore my right knee MCL ligament and ruptured the ACL Ligament. MCL will heal in time but ACL is…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
