Jason Edge's Discussions (2,290)

Discussions Replied To (1672) Replies Latest Activity

"My car is on 4 12" Race Ramp wheel cribs where it has been for several months and wi…"

Jason Edge replied on Saturday to Dino Diaries - July 11, 2025 - Busted!

4 on Saturday
Reply by Jason Edge

"Here is an alternate version of an original print ad I had posted back in March that…"

Jason Edge replied Jul 6 to Cadillac Original Ads - 1964 Standard Ads

27 Jul 6
Reply by Jason Edge

"Here is a picture of sets I have put together: "

Jason Edge replied Jul 5 to Dino Diaries - July 5, 2025 - Cad Plated Trans Linkage Installed

1 Jul 5
Reply by Jason Edge

"63's and 64's had one block."

Jason Edge replied Jul 3 to Convertible bumper jack

13 50 minutes ago
Reply by Alan Clark

"There should be clips in each end inside the opening as seen in my picture below. If…"

Jason Edge replied Jun 23 to Convertible bumper jack

13 50 minutes ago
Reply by Alan Clark

"I have many, used but very  nice condition for $1 each (75 cents after discount). Ju…"

Jason Edge replied Jun 15 to where to find 1963 Cadillac Plastic Door Pin Anchors

2 Jun 15
Reply by Jason Edge

"I have never taken it to a GN but plan to take it to Charlotte in 2026. I have yet t…"

Jason Edge replied Jun 11 to Future of CLC Judging

6 Jun 11
Reply by Jason Edge

"No deductions for items items to your vehicle that was a factory or factory authoriz…"

Jason Edge replied Jun 11 to Future of CLC Judging

6 Jun 11
Reply by Jason Edge

"It will give you a much easier feeling once you get the recored radiator back in the…"

Jason Edge replied May 28 to Dino Radiator Leak - Time to Recore!

36 Jun 6
Reply by Bill Wolf

"I picked up the 12th batch of cadmium plated parts and have dumped out 3 totes of 9…"

Jason Edge replied May 25 to 4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday

3 May 25
Reply by Dennis P. DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

Convertible bumper jack

Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 50 minutes ago. 13 Replies

My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk.  Anyone have a picture of the item I should find?Continue

Timing cover corrosion

Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion 3 hours ago. 0 Replies

Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump  Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Logan Robb 7 hours ago. 2 Replies

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

Dino Diaries - July 11, 2025 - Busted!

Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies

So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service