David Thomas's Discussions (138)
Photos
Members
Forum
Bendix Power Brake Unit Power Section
Started by Mathis Richter in 1963/64 Cadillac Specific Discussion. Last reply by Chris Codd yesterday. 7 Replies 0 Likes
Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue
Third brake light -help please.
Started by paul k in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 8 Replies 0 Likes
Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue
Extra speakers in the cadillac.
Started by paul k in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue
429 and 400 trans. for sale
Started by Mark C Bills in For Sale. Last reply by Tony and Ginny 429 on Monday. 6 Replies 0 Likes
I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue
Blog Posts
1964 Cadillac Fleetwood sixty special / transmission dipstick needed
Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment 0 Likes
How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much
1963 Cadillac hood driver side hinge
Posted by Steven on September 16, 2020 at 9:23am 1 Comment 0 Likes
Hello,
Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit?
Thanks
Steven
Bad Guage?
Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments 0 Likes
So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…
ContinueWebsite
Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments 0 Likes
I have been working on a website-----www.fritzsautorepair.com-----
Does anyone have suggestions?
Events
Videos
© 2020 Created by Jason Edge.
Powered by
