I've posted a few times about the strange issue I have with the trans on my 64 Fleetwood. When it gets warm and up to temp, I loose 3rd gear, but I never loose reverse. According to multiple sources, 3rd should be find as long as I have reverse. When the trans DOES shift, it does so with ease. I check and maintain the fluid level nearly daily as it does have a leak. But I have yet to find any answers in regards to this issue.
I have a new pan seal and filter as a last Hail Mary to see if that is the issue, but I am not keeping my hopes up. The way I see it, if the filter doesn't solve my issues, I have two choices.
1) I purchase a used trans from Jason and have it freighted to me here in Illinois. I order some new seals and have a trans shop swap them around for me. I'm not sure the exact cost for this option, but I am thinking it may save a little money vs. doing a rebuild.
2) I just save for the rebuild. I am leaning towards this option as then I know the trans is worry free for the foreseeable future and I can drive and enjoy the car. However, I am getting quotes in the $2,500 range which is a little more than I want to spend in the next 6 mos to a year. IF I do go this route, I'm looking for someone who has recently had their 64 "TH400" rebuilt. I had two shops in my area tell me they won't touch a 64 because the internals are different than that of the later years. What overhaul kit did you purchase? How long did it take? Just factfinding at this point and would love your input!
Thanks!
Logan
Tags:
As a follow up because I didn't want to make the post too long. I have replaced the vacuum modulator, serviced the governor and inspected that it was moving freely. Those were the two most common issues I have seen others have. Outside of replacing the filter-I am out of ideas and so is the trans shop that states they can rebuild a 64 THM400.
It is true that 64 TH400 is not 100% identical to later years, but those differences are minor. Even here in Finland, far away from Caddy home, I can get 64 specific parts without problem.
Unfortunately I am not able to tell the solution for the problem in you caddy.
Can you change from 2nd to 3rd gear manually? ie. With warm engine drive fast (>50 mph) with stick in 2nd gear and then move it to 3rd position. If it changes ok then valves and bands seem to work ok with warm engine. In that case I would search the problem from governor even you have changed that.
From my research, everything internally seems to be OK. When it DOES shift to 3rd, it shifts very well. Reverse functions nice and strong when the engine is warm as well. Perhaps when I replace the filter and pan seal, Ill check all of those areas again as well. Certainly won't hurt anything!
Logan.
I’m unaware of any vacuum shifter on the back of the carb. To my knowledge, there is a vacuum line there that goes to the modulator on the side of the trans. But no component other than the line.
When I change the pan seal and filter, I’ll certainly check the gov again. Might replace the entire vacuum line as well. Logan
Per she shop manual on pg 10A-22, Fig 10A-16 look at H-I-K-N
Travis J. Hensley Online
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 10 hours ago. 8 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 6 Replies 0 Likes
So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
After dinner last night, we went for a quick cruise as the weather was cooler and the sun set was looking really good!Out of nowhere, a pop up shower appeared overhead and down-poured as we were…Continue
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb on Monday. 11 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by