Spacer in steering column
When fixing the turn signal switch in my 64, I found out that the spacer is missing in steering column. This is non-tilt version. with amazing luck I managed to acquire missing spacer within few days.
Which position the spacer should be installed? Based on diagram, the pin is facing down. I wonder if anyone has photo how the spacer is positioned.
Replies to This Discussion
-
Permalink Reply by Matti Roth on
-
This spacer is not only making the cancel of turning signal, but it keeps that upper bearing tight. Without the spacer the bearing is sloppy and steering wheel feels a bit loose.
The pin in spacer need to point upward and goes to the hole in bottom of the steering wheel.
Somebody has been trying to repair the turn signal switch and did not install the spacer anymore for whatever reason.
Members
-
Travis J. Hensley Online
-
-
Forum
Gump(Pat Westphal) you’re a gosh darn genius!
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal yesterday. 2 Replies 0 Likes
So I have been having problems with my brake lights. At first I thought it was both sides and turns out it is only the drivers side. Also, I thought the blinker worked and it didn’t and turned out…Continue
Front grill
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 11 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Steering slack/play
Started by Nile Bolen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 4 Replies 0 Likes
I checked the Help page and did a search on the site but didn't see any subjects on steering play/slack. Since I had someone complete a front end rebuild (Kanter kit, all the control arm bushings,…Continue
Add cruise control/Aftermarket Cruise control
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler on Monday. 12 Replies 0 Likes
Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
