Started this discussion. Last reply by Jason Edge Aug 15, 2024. 5 Replies 0 Likes
Hi,is anyone using hi-jackers or similar as rear shocks? I did not find which type would fit 64.Continue
Started this discussion. Last reply by 3gk350qap28u3 Oct 8, 2023. 2 Replies 0 Likes
When fixing the turn signal switch in my 64, I found out that the spacer is missing in steering column. This is non-tilt version. with amazing luck I managed to acquire missing spacer within few…Continue
Started this discussion. Last reply by b4382978a0ca44ab9d351688c569b49a Aug 16, 2023. 6 Replies 0 Likes
Any idea how that idle vent valve is supposed to work in 64 Rochester 4GC? There is nothing in 64 Shop Manual and nothing in 64 Delco Rochester 4GC Bulletin. I assume open when idle and closed when…Continue
Started this discussion. Last reply by Matti Roth Mar 23, 2023. 2 Replies 0 Likes
The steering gear in my 64 is leaking from steering shaft side and I need to rebuild it. I have used steering gear from 70`s Monte Carlo available. Is there any reason why not to use that temporarily…Continue
Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter.
- Click on www.join.6364cadillac.com for more information on joining the 1963/64 Cadillac Chapter and the Cadillac LaSalle Club.
Be sure and check out all the links and pages and make yourself at home. The Help Page at www.help.6364cadillac.com will have links to many useful articles and information about our Cadillacs.
Travis J. Hensley Online
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 4 hours ago. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion 7 hours ago. 0 Replies 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Started by Bobby Brown in General Discussion. Last reply by Logan Robb 11 hours ago. 2 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by