My car still has its "T-3"headlamps and they shed poor, yellow-tinted light. I'd like to replace them with something that most folks on this web site use, that would shed good light and don't heat up the wiring with too many amps.
Survey says?
Norm
Added by Norman Silverman on December 15, 2018 at 9:07pm — 11 Comments
Although the radiator was not leaking, nor was the car running hot, I tool out the radiator today to have it boiled out and rodded out. Then I changed the oil and filter (filter is very easy to reach with the radiator out), then the thermostat got changed.
I'll have the radiator back from the shop on Monday, and will reinstall it then.
Still having…
ContinueAdded by Norman Silverman on December 8, 2018 at 9:29pm — 6 Comments
I went to replace the bulb in the trunk light socket and was met by something I had never seen before: the socket appears to be made in two thicknesses. First a wide one with appropriate cut outs on the side where the bulb nipples fit in, then a long slender shaft (with a cardboard tubular insert) down to the positive contact. I've never seen anything like this. Only thing I can figure is that it is designed to have a metal rod inside the cardboard shaft that…
ContinueAdded by Norman Silverman on December 4, 2018 at 10:14pm — 2 Comments
I got the rebuilt Power module back from the rebuilder and reinstalled it.
It's been a while since i posted on this topic so I will remind those reading that the main problem I have been chasing is that i can't get air out of the AC or the heater ducts-even though the heat/ac vacuum solenoid is working. Today, I found out why.
I installed the newly rebuilt Module but it…
ContinueAdded by Norman Silverman on December 4, 2018 at 12:51am — 2 Comments
2025
2024
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
2013
2012
Started by Jose Raul Ramirez in Wanted to Buy. Last reply by Russ Austin yesterday. 1 Reply 0 Likes
The body shop lost my armrests! I need the driver's side and passenger side. The ISSUE is my 63 did not come with power windows It has manual crank windows so the armrests are not setup for switches.…Continue
Started by Jason Edge in General Discussion on Wednesday. 0 Replies 0 Likes
If you follow my Classic Cadillac Parts Page you have already seen this a couple days ago but thought I would share here as it continues the replacement of tired, crusty hardware on "Dino" with…Continue
Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin Aug 17. 8 Replies 0 Likes
I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock. Did not know.Just had engine…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler Aug 16. 16 Replies 0 Likes
Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by