Joe DiIaconi's Discussions (471)

Photos

  • Add Photos
  • View All

Forum

Turn signal

Started by Jeroen Welgemoed in 1963/64 Cadillac Specific Discussion. Last reply by Jeroen Welgemoed 2 hours ago. 4 Replies

Hi all. It has been a while since i last asked or posted something. My car has his engine put back in and i am now just working om some loose ends.The last thing i have to do before i can get on the…Continue

New transmission mounts for sale.

Started by Russ Austin in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 13 hours ago. 1 Reply

I have 3 new transmission mounts for the 64 Turbo Hydromatic.  New from Steelerubber, still in the bag. I took one out to take a picture.These retail for 127.40  but you can get them from me for…Continue

63 jetaway transmission

Started by Scott L Foltz in Restoration Discussion. Last reply by Russ Austin 16 hours ago. 4 Replies

Hello and thank you for letting me join this group. While I was driving my 63 model 62 my trans cooler line blew off and needless to say I ran out of fluid. The next day I replaced the rubber hose…Continue

Tags: Transmission

CLC 2019 Grand National - Louisville, Kentucky, June 11-15, 2019

Started by Jason Edge in General Discussion. Last reply by Marty Smith 22 hours ago. 35 Replies

1963/64 Cadillac Chapter 2019 Grand National Page www.2019GN.6364Cadillac.com…Continue

Tags: National, Grand, CLC, 2019

Blog Posts

Cadillac Returns to its Roots Under New Leadership

Posted by Jeff Kinzler on May 1, 2019 at 12:30am 3 Comments

Cadillac’s new boss says they should stop trying to build BMWs and go back to building Cadillacs again.

What do you think? 

https://carbuzz.com/news/cadillac-finally-admits-what-everyone-knew-for-years

Radiator And Shrouds

Posted by Dominic Salemi on April 24, 2019 at 3:36pm 1 Comment

Hello

Anyone have a decent radiator and shrouds and hardware for a 1964 Cadillac deville. I have an alum. radiator and I'm deciding on to fix it or back to the original one. If I fix it I won't need parts.

Thanks

64 Recirc/Fresh Air Door Actuator replaced; FROM THE INSIDE.

Posted by Norman Silverman on February 4, 2019 at 11:21pm 8 Comments

I am happy to report that I have successfully replaced the Fresh Air/Recirc door actuator that is located on the blower box-and have done so without having to remove the blower box. I did it by taking out the glove box and attacking it from the back.  It took several days, LOTS of patience and some band-aids, but it is done. THE most difficult part -BY FAR- is to remove and then replace the screw that sits on the actuator arm, connecting it to the fresh…

Continue

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service