I've started replacing my worm gear clamps with correct for 63/64 tower clamps and started with the radiator hose clamps on the top and had to screw the 2 1/16" top clamps almost all the way to get them to tighten. After running the engine I noticed I had a drip leak on the top radiator side clamp and I…
ContinueAdded by Jason Edge on May 19, 2013 at 9:00am — 2 Comments
I would like to obtain a copy of the Self-Starter's article on the 429 engine series. I think it was originally published in the July 2003 edition. Does anyone have a copy to share or any ideas of how to obtain a copy?
Thank you.
Chris McBride
Added by Chris McBride on May 18, 2013 at 10:31am — 3 Comments
I installed a tilt steering column from a 63 Caddy parts car in my 63 convertible and am having trouble with the horn. Does anyone recall if there are spacers, insulators, or washers around the plastic backed, brass horn ring? I can't tell from the service bulletin, but the horn shorts out and the contact ring is the location of the short. Any advice would be greatly appreciated.
Added by Joseph Rabbene on May 18, 2013 at 8:50am — 1 Comment
Added by Jason Edge on May 18, 2013 at 6:56am — 1 Comment
I'm really looking forward to our local meet-up today with the Eastern NC CLC region and had the 64 CDV out for a spin last night with Cheryl and Lucky. It's cleaned up and full of gas and ready for today!
Yesterday I replaced some of the worm gear hose clamps with tower clamps and worked on a few other odds and ends and she is purring like a kitten!
Here's a quick picture of the Caddy outside our local AutoZone picking up some supplies. That is Miss Lucky looking out the…
ContinueAdded by Jason Edge on May 18, 2013 at 6:52am — 1 Comment
Added by Jason Edge on May 17, 2013 at 4:29pm — 1 Comment
guys why would my exhaust manifolds be turning frost color i think they have slight leaks would that cause it thanks for any input
Added by tim sparks on May 17, 2013 at 9:52am — 5 Comments
Added by Jason Edge on May 16, 2013 at 5:29pm — 1 Comment
Some of my vacuum tubes are getting old and a bit brittle. Where can I get some new with the correct color-lines? Any tips?
Added by Christian Doerk on May 16, 2013 at 9:01am — 4 Comments
Added by Jason Edge on May 15, 2013 at 6:37am — No Comments
Added by Jason Edge on May 14, 2013 at 6:14am — No Comments
Added by Jason Edge on May 13, 2013 at 8:00pm — No Comments
Added by Jason Edge on May 12, 2013 at 6:59pm — No Comments
Added by Jason Edge on May 12, 2013 at 6:56pm — No Comments
Our local CLC chapter had their annual show at Covert Cadillac in Austin TX yesterday.
Added by Kurt on May 12, 2013 at 11:51am — No Comments
Added by Jesper Krog Jensen on May 12, 2013 at 11:22am — 1 Comment
Added by Jason Edge on May 11, 2013 at 8:27am — No Comments
Added by Jason Edge on May 10, 2013 at 6:23am — 1 Comment
Added by Jason Edge on May 9, 2013 at 6:38am — No Comments
Added by Jason Edge on May 8, 2013 at 4:11pm — No Comments
2024
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
2013
2012
Started by Jason Edge in General Discussion. Last reply by Jason Edge 6 hours ago. 1 Reply 0 Likes
I have very limited space in my 3 bay garage with the left and right bay used for storage and work tables, etc leaving the narrow center aisle for my 1964 Coupe de Ville Dino. Six years ago I bought…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Thursday. 10 Replies 0 Likes
Got to spend a couple of hours working on the choke on carter carb. I was able to take it apart, clean it up and reinstall, but a couple of questions arose. Which side does the choke coil go on the…Continue
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin Dec 30, 2024. 2 Replies 0 Likes
I'm looking for a set of driver side and passenger side front kick panel covers. Condition and type of upholstery is not important, it will be getting redone, as long as the actual panels are in…Continue
Started by tim sparks in General Discussion. Last reply by tim sparks Dec 28, 2024. 2 Replies 0 Likes
does anyone know of a rebuild kit for 1964 cadillac tilt steering.looked in help section didnt see anything.thannks in advanceContinue
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
ContinuePosted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
© 2025 Created by Jason Edge. Powered by